Yamaha MT 10 2016 User Manual

CRANKSHAFT AND BALANCER SHAFT
5-85
EAS31077
INSTALLING THE CRANKSHAFT
1. Install:
• Crankshaft journal upper bearings
(into the upper crankcase)
• Crankshaft journal lower bearings
(into the lower crankcase)
• Crankshaft
TIP
• Align the projections “a” on the crankshaft jour-
nal bearings “1” with the notches “b” in the
crankcase.
• Be sure to install each crankshaft journal bear-
ings in its original place.
EAS31799
INSTALLING THE THRUST BEARING
1. Install:
• Thrust bearing “1”
TIP
• Install the thrust bearings to the both side of the
journal #4 of the upper crankcase.
• The thickness of the thrust bearing is only one.
No need to adjust the clearance between the
thrust bearing and the crankshaft.
• Install the thrust bearing with the grooves “a”
side is facing the crankshaft.
• Apply engine oil on the grooves “a” side of the
thrust bearing.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Insert the thrust bearing “1” into the slot of the
upper crankcase as shown in the illustration
and slide it in the direction of the arrow.
TIP
When installing the thrust bearing, shift the
crankshaft to the left to widen the gap between
the crankshaft and the crankcase.
b. Insert the thrust bearing “2” into the slot of the
upper crankcase as shown in the illustration
and slide it in the direction of the arrow.
TIP
When installing thrust bearing “2”, shift the
crankshaft to the right to widen the gap between
the crankshaft and the crankcase.
c. Check that the thrust bearing is inserted prop-
erly into the groove of the crankcase.
J 1 J 2 J 3 J 4
1
a
b
1
a
1
2

Yamaha MT 10 2016 Specifications

General

Displacement	998 cc
Bore x Stroke	79.0 mm x 50.9 mm
Maximum Power	118.0 kW (160.4PS) @ 11, 500 rpm
Fuel System	Fuel Injection
Starter System	Electric
Transmission	6-speed
Final Transmission	Chain
Front Tire	120/70 ZR17M/C (58W)
Rear Tire	190/55 ZR17M/C (75W)
Length	2, 095 mm
Width	800 mm
Height	1, 110 mm
Seat Height	825 mm
Wheelbase	1, 400 mm
Minimum Ground Clearance	135 mm
Wet Weight	210 kg
Fuel Tank Capacity	17 liters
Engine Type	Liquid-cooled, 4-stroke, DOHC, inline 4-cylinder
Compression Ratio	12.0:1
Torque	111 Nm @ 9, 000 rpm
Front Suspension	Telescopic forks, Ø 43 mm
Rear Suspension	Link-type suspension
Front Brake	Dual 320mm hydraulic disc, ABS
Rear Brake	Hydraulic disc, 220 mm
Frame	Aluminum Deltabox