Yamaha MTM155 - Page 26

Instrument and control functions
4-7
4
EAU87600
Fuel reserve tripmeter
If the last segment of the fuel meter
starts flashing, the display automati-
cally changes to the fuel reserve trip-
meter “TRIP F” and starts counting the
distance traveled from that point.
To reset the fuel reserve tripmeter,
push the “RESET” button until it is re-
set.
TIP
If you do not reset the fuel reserve trip-
meter manually, it will reset automati-
cally and disappear from the display
after refueling and traveling 5 km (3 mi).
EAUN2660
Clock
The clock uses a 12-hour time system.
To set the clock
1. Push the “SELECT” button to
change the display to the clock.
2. Push the “SELECT” button until
the hour digits start flashing.
3. Use the “RESET” button to set the
hours.
4. Push the “SELECT” button and
the minute digits start flashing.
5. Use the “RESET” button to set the
minutes.
6. Push the “SELECT” button to con-
firm the settings.
EAU87740
Instantaneous fuel consumption
display
This display shows the fuel consump-
tion under the current riding condi-
tions. It can be set to either “km/L” or
“L/100 km”. To switch the fuel con-
sumption measurement units, push the
“SELECT” button until the measure-
ment units change.
z “km/L”: the distance that can be
traveled on 1.0 L of fuel.
z “L/100 km”: the amount of fuel
necessary to travel 100 km.
TIP
When traveling under 10 km/h (6 mi/h),
“_ _._” is displayed.
1. Fuel reserve tripmeter
1
1. Clock
1
1. Instantaneous fuel consumption display
1
UB1VE0E0.book Page 7 Tuesday, September 3, 2019 1:19 PM