Yamaha RM1x - Page 71

RM1x SEQUENCE REMIXER 71
PATTERN MODE
❏ Chorus Edit
page1
page2
❏ Reverb Edit
page1
9. Effect
Parameter Values Function
LFO Frequency 0.00Hz ... 39.7Hz Sets delay modulation frequency.
LFO Depth 000 ... 127 Sets delay modulation depth.
FB Level -63 ... 00 ... +63 Sets level at which the delay output is returned to the input (nega-
tive values invert the phase).
Delay Offset 000 ... 063 Sets offset value for delay modulation.
Parameter Values Function
Send Chorus to Reverb 000 ... 127 Sets level on bus from chorus block to reverb block.
Chorus Pan L63 ... C ... R63 Sets stereo positioning of signal from chorus block.
Parameter Values Function
Reverb time 0.3s ... 30s Sets reverb length.
Diffusion 00 ... 10 Sets spread of the reverb.
InitDelay 00 ... 63 Sets delay time until the early reflections.
HPF Cutoff THRU, 22Hz ... 8.0kHz Sets frequency at which the high pass filter will cut the low range.
* For information about how to change values, refer to the Basic Operation (page26).
* For information about how to change values, refer to the Basic Operation (page26).
* For information about how to change values, refer to the Basic Operation (page26).