YCO-1127-12-08
PPC-300WP Operation Manual
01 - Function Selection
The PPC-300 series has three user selectable weighing functions: Packing, Checkweighing, and Grad-
ing. The value of this parameter determines which, if any, of the three functions is enabled. For more
information on these functions, please see section IV of this manual.
02 - Number of Grades
The grading function can be set to have 2 to 15 grades. The higher the number of grades, the fewer
the number of different grading setups that can be stored in memory. Please see section IV of this
manual for more information on the grading function.
Setting 002 003 004 005 006 007 008 009 010 011 012 013 014 015
# of grades 2 3 4 5 6 7 8 9 10 11 12 13 14 15
# of setups 66 49 39 33 28 24 22 19 18 16 15 14 13 12
03 - Buzzer
This parameter only applies to the PPC-300WP.
04 - Grade Stability
The grading function can be set to either show a real time display of the calculated grade, or to show
no grade value until a stable weight reading has been acheived. If this parameter is enabled (001) then
the scale will display two dashes in place of the grade value until the weight reading is stable. Then it
will display the appropriate grade.
05 - Auto-off Timer
The PPC-300 series of scales can be set to automatically turn off after a specied time with no activity.
This feature only operates when the scale is using batteries for power.
06 - Automatic Tare
The packing function can be set to automatically tare an initial stable weight, and to automatically clear
the tare when the scale returns to zero.
07 - Flashing Display
This feature is available for the packing, checkweighing and grading functions. For the packing and
checkweigh functions, this feature can be set to operate as specied in the preceeding table. Any set-
ting between 001 and 004 will cause the display in the grading function to ash when any weight above
or equal to the rst, lowest grade weight is detected. Setting 005 is only appicable to the PPC-300WP.
21 - Vibration Compensation
Environments that experience "noise" issues caused by external vibration can set this parameter for a
more stable reading at the cost of a longer response time to calculate a stable weight.
22 - Units at Power On
The units (kg, lb, oz, or lb-oz) that the scale will indicate when it is turned on.
V User Parameters
23
To Next Page
Loading...
