INTRODUCTION 1
1-1
1 INTRODUCTION
This manual contains information for post processor to create EIA/ISO program according to the
machine. This manual can be used as an EIA/ISO programming manual.
This manual describes the machines of the INTEGREX e-series, INTEGREX i-series, and
VORTEX i-series.
The INTEGREX e-series and INTEGREX i-series are multi-tasking machines and support both
milling and turning. The VORTEX i-series is a machining center and supports milling only.
Note that the turning function is excluded from the descriptions of the VORTEX i-series.
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
To Next Page
Loading...