YAMAZAKI MAZAK VORTEX i Series User Manual

PROGRAMMING MANUAL
INTEGREX e series
INTEGREX i series
VORTEX i series
Programming Data for Post Processors
Manual No.: HA12PB0013E
Serial No.:
Before using this machine and equipment, fully understand the contents of this
manual to ensure proper operation. Should any questions arise, please ask the
nearest Technical Center or Technology Center.
IMPORTANT NOTICE
1. Be sure to observe the safety precautions described in this manual and the contents of the
safety plates on the machine and equipment. Failure may cause serious personal injury or
material damage. Please replace any missing safety plates as soon as possible.
2. No modifications are to be performed that will affect operation safety.
3. For the purpose of explaining the operation of the machine and equipment, some illustrations
may not include safety features such as covers, doors, etc. Before operation, make sure all
such items are in place.
4. This manual was considered complete and accurate at the time of publication, however, due to
our desire to constantly improve the quality and specification of all our products, it is subject
to change or modification. If you have any questions, please contact the nearest Technical
Center or Technology Center.
5. Always keep this manual near the machinery for immediate use.
6. If a new manual is required, please order from the nearest Technical Center or Technology
Center with the manual No. or the machine name, serial No. and manual name.
Issued by Manual Publication Section, YAMAZAKI MAZAK CORPORATION, Japan
04.2017
Copyright (C) 2016 YAMAZAKI MAZAK CORPORATION. All Rights Reserved.
Original Instructions
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
Serial No. 294060
AVANS 294060

YAMAZAKI MAZAK VORTEX i Series Specifications

General

Brand	YAMAZAKI MAZAK
Model	VORTEX i Series
Category	Computer Hardware
Language	English

Summary

1 INTRODUCTION

2 MACHINE INFORMATION

2-1 Controlled Axis Information

Describes composition of controlled axes, machine specification, stroke, input limit, speed, and feed rates.

2-2 Magazine

Provides information on the magazine capacity for different machine specifications.

3 NC COMMAND

3-1 Programming Format

Explains the structure of NC programs, including words and addresses.

3-2 Command

Explains commands like tool indexed function, program code, and specific G/M codes.

4 MACHINING PROGRAM

4-1 Set Up

Explains how to set workpiece origin and tool offset parameters.

4-2 Programming Composition

Explains the composition of machining programs into preparation, machining, and end motions.

4-4 Machining Motion

Explains different machining motions like turning, drilling, 3-axis, 4-axis, and 5-axis.

4-6 Programming for Compound Machining (ST Specification)

Explains programming for compound machining, including separate, parallel, and dual workpiece machining.

5 SUPPLEMENT

5-1 Detail of Preparatory Function

Covers details of preparatory function commands, including G-codes like Dwell and High-speed machining mode.

5-2 Detail of Miscellaneous Function

Details miscellaneous functions, including M-codes for programmed stop, optional stop, subprogram call, and spindle control.

5-3 Restriction of Combination

Shows compatibility between different G-codes, like high-speed machining mode and other functions.