YAMAZAKI MAZAK VORTEX i Series User Manual

4 MACHINING PROGRAM
4-58
4-6-2 Sample programs
See 4-4 because as command codes depend on machining method.
1. Separate machining
This section explains how to make separate machining.
Separate machining pattern is shown in the following.
<Single workpiece>
Separate machining
: Possible
EIA/ISO
1st spindle
2nd spindle
Turning
Milling
Turning
Milling
Upper turret
 (Note)


 (Note)
Lower turret

 (Note)
 (Note)

Note : Sample programs are shown in this manual.
Upper turret
HD1
Lower turret
HD2
Upper turret
HD2
Lower turret
HD2
Separate machining
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
Serial No. 294060

YAMAZAKI MAZAK VORTEX i Series Specifications

General

Brand	YAMAZAKI MAZAK
Model	VORTEX i Series
Category	Computer Hardware
Language	English