MACHINING PROGRAM 4
4-67
2. Program composition
2. Parallel machining
This section explains how to make parallel machining
Parallel machining pattern is shown in the following.
<Single workpiece>
Parallel machining (on either spindle side with both turrets)
: Possible —: Inapplicable
Note 1: Simultaneous milling is possible in the EIA/ISO programming format, indeed, but take
care of a phase difference occurring for machine structural reasons.
Note 2: Sample programs are shown in this manual.
Instruction in
Preparation motion
For machining
Program composition element
Instruction in
Preparation motion
For machining
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
To Next Page
Loading...
Need help?
General
