To Next Page

To Previous Page

C-1

CONTENTS

1 INTRODUCTION ................................................................................. 1-1

2 MACHINE INFORMATION .................................................................. 2-1

2-1 Controlled Axis Information ................................................................................ 2-1

2-1-1 Composition of controlled axes ............................................................................. 2-1

2-1-2 Outline of the machine structure ............................................................................ 2-5

2-1-3 Machine stroke ...................................................................................................... 2-6

2-1-4 Input limitation ..................................................................................................... 2-15

2-1-5 Rotating speed .................................................................................................... 2-15

2-1-6 Rapid feed rate.................................................................................................... 2-19

2-1-7 Cutting feed rate .................................................................................................. 2-22

2-2 Magazine .......................................................................................................... 2-28

2-2-1 INTEGREX i ........................................................................................................ 2-28

2-2-2 INTEGREX i-S .................................................................................................... 2-28

2-2-3 INTEGREX i-ST .................................................................................................. 2-28

2-2-4 INTEGREX e-H ................................................................................................... 2-29

2-2-5 INTEGREX e-H-S ............................................................................................... 2-29

2-2-6 INTEGREX e-H-ST ............................................................................................. 2-29

2-2-7 INTEGREX i-V .................................................................................................... 2-30

2-2-8 INTEGREX e-V ................................................................................................... 2-30

2-2-9 VORTEX i-V ........................................................................................................ 2-31

3 NC COMMAND ................................................................................... 3-1

3-1 Programming Format .......................................................................................... 3-1

3-1-1 Words and addresses ........................................................................................... 3-1

Serial No. 294060

YAMAZAKI MAZAK VORTEX i Series User Manual

Questions and Answers: