YAMAZAKI MAZAK VORTEX i Series User Manual

4 MACHINING PROGRAM
4-68
Two-process control by one program Parallel machining
This function is the two systems can be controlled by a single program.
(It is not necessary to change the parameter when this function is used.)
Note 1: Description in parentheses is not directly relate with machining.
Note 2: (U.T.): These commands are ordered of Upper turret machining.
Note 3: (L.T.): These commands are ordered of Lower turret machining.
G28X0Z0
•
•
G109L1
M901
•
M950(U.T.)
•
•
M30(U.T.)
G109L2
M901
•
•
M950(L.T.)
•
•
M30(L.T.)
Common
Upper turret
(System 1)
Lower turret
(System 2)
Operation
Start of program
G109L1
(Upper turret)
G109L2
(Lower turret)
Common
M950(U.T.)
M950(L.T.)
M30(U.T.)
Upper turret end
M30(L.T.)
Lower turret end
Wait for same command
in another system when
call the waiting command.
M901
M901
Select the same head
Program
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
Serial No. 294060

YAMAZAKI MAZAK VORTEX i Series Specifications

General

Brand	YAMAZAKI MAZAK
Model	VORTEX i Series
Category	Computer Hardware
Language	English