YAMAZAKI MAZAK VORTEX i Series User Manual

4 MACHINING PROGRAM
4-2
Tool length offsetting
Pattern
Data items used
Parameter
Programming
format
F94 bit 7
F93 bit 3
[1]
Tool offset
Tool offset No.
0
0
G43H
[2]
MATATROL Tool Data
Length
1
1
T + G43
Length + Offset No.
Length + LENG. CO.
T + G43H
[3]
Offset No.
LENG. CO.
1
0
G43 H
[4]
Tool offset No. + Tool Data
Tool offset No. + Length
0
1
T + G43H
4-1-3 Parameter for Nose / Tool radius compensation
This manual explains how to make machining programs when below parameters are set by the
recommended value.
With the recommended setting, nose R or tool diameter data is taken from MAZATROL tool data,
and (additional) tool radius offset is taken from tool offset data.
Parameter for Nose/Tool radius compensation
parameter
bit
meaning
value
description
standard
recommended
F92
7
Radius/NOSE-R in the Tool
Data display for an EIA/ISO
program
0
invalid
0/1
1
1
valid
F94
7
Tool offset amount
effectuated in an EIA/ISO
program
0
ACT-CO. of tool offset
1
0
1
OFFSET No. of tool data
ACT-CO. of tool data
Note : Standard parameter of “F92bit7”: i150->0 i200/400/300->1
Tool radius compensation
Pattern
Data items used
Parameter
Programming
format
F92 bit 7
F94 bit 7
[1]
Tool offset No.
Tool offset No.
0
0
G41/G42 D
[2]
Tool Data (MAZATROL)
Radius + OFFSET No.
NOSE-R/Radius + ACT-CO.
1
1
G41/G42 T
[3]
ACT-CO.
OFFSET No.
0
1
G41/G42 T
[4]
Tool Offset + Tool Data
Tool offset No. + NOSE-R/Radius
1
0
G41/G42 D + T
recommended
recommended
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
Serial No. 294060

YAMAZAKI MAZAK VORTEX i Series Specifications

General

Brand	YAMAZAKI MAZAK
Model	VORTEX i Series
Category	Computer Hardware
Language	English