YAMAZAKI MAZAK VORTEX i Series User Manual

4 MACHINING PROGRAM
4-14
11. Others
Command any as required besides above ten commands.
This section explains “cutting level selection M codes” and mist collector.
A. Accuracy level (M821 to M830) (Option: High-Speed Smoothing Control)
Each work piece can be machined under the specific cutting conditions by specifying one of the
ten accuracy levels.
The accuracy level is to be specified either by an M-code in the program or manually in the
CUTTING LEVEL SELECT window.
This Table shows M-code input method.
M-codes
M821
Accuracy level 1
M822
Accuracy level 2
M823
Accuracy level 3
M824
Accuracy level 4
M825
Accuracy level 5
M826
Accuracy level 6
M827
Accuracy level 7
M828
Accuracy level 8
M829
Accuracy level 9
M830
Accuracy level 10
B. Mist collector (M613) (Option)
This code starts and stops mist collector.
M613: Mist collector ON
M614: Mist collector OFF
Highest Speed
Highest accuracy
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
Serial No. 294060

YAMAZAKI MAZAK VORTEX i Series Specifications

General

Brand	YAMAZAKI MAZAK
Model	VORTEX i Series
Category	Computer Hardware
Language	English