EasyManuals Logo

YAMAZAKI MAZAK VORTEX i Series User Manual

YAMAZAKI MAZAK VORTEX i Series
220 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
4 MACHINING PROGRAM
4-30
D. G-codes/M-codes
See the document [99 Supplement] for details.
G-codes
G-codes
Group
Description
G61.1
13
High-accuracy mode (Geometry compensation)
G68.2P1
16
Inclined-plane machining ON
Using roll, pitch, and yaw angles
G53.1
0
Tool-axis direction control
G43
8
Tool length offset (+)
G69
16
Programmed coordinate rotation OFF
G64
13
Cutting mode (Geometry compensation OFF)
Note : The geometry compensation reduces geometry errors caused by the delay in the
smoothing circuits and servo systems.
High-accuracy mode
G codes
Description
G61.1
Geometry compensation
G61.2
Modal spline interpolation
Note 1: is G-code used by sample program.
Note 2: G61.2 is a geometry compensation with fine spline interpolation feature for a further
better quality surface for the CAM-made minute increments block by block data
operation.
Inclined-Plane Machining
G codes
Description
G68.2[P0]
Using Eulerian angles
G68.2P1
Using roll, pitch, and yaw angles
G68.2P2
Using three points in the plane
G68.2P3
Using two vectors
G68.2P4
Using projection angles
G68.3
Using tool-axis direction
Note 1: is G-code used by sample program.
See the programming manual, if you use the other patterns.
Note 2: See the document [supplement] or “4-4-2 1. Hole machining” for details of
inclined-Plane Machining.
M-codes
M-codes
Description
M107
B-axis clamping
M108
B-axis unclamping
M210
Turning spindle 1 C-axis clamping
M212
Turning spindle 1 C-axis unclamping
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the YAMAZAKI MAZAK VORTEX i Series and is the answer not in the manual?

YAMAZAKI MAZAK VORTEX i Series Specifications

General IconGeneral
BrandYAMAZAKI MAZAK
ModelVORTEX i Series
CategoryComputer Hardware
LanguageEnglish

Related product manuals