YAMAZAKI MAZAK VORTEX i Series User Manual

4 MACHINING PROGRAM
4-18
M-codes
M-codes
Description
M107
B-axis clamping
M108
B-axis unclamping
M250
Spindle speed attainment check
Compound Fixed Cycles
G codes
Function
G270
Finishing cycle
G271
Longitudinal roughing cycle (leaving finishing allowance)
G272
Transverse roughing cycle (leaving finishing allowance)
G273
Contour-parallel roughing cycle

G274
Longitudinal cut-off cycle
G275
Transverse cut-off cycle
G276
Compound thread-cutting cycle
Note :  is G-code used by sample program.
See the programming manual, if you use the other patterns.
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
Serial No. 294060

YAMAZAKI MAZAK VORTEX i Series Specifications

General

Brand	YAMAZAKI MAZAK
Model	VORTEX i Series
Category	Computer Hardware
Language	English