BEFORE YOU OPERATE
JH Series Operation Manual 59
5. Check the coolant level in the reservoir.
The level should be at the FULL mark
(Figure 15, (2)). Add coolant if
necessary.
Never pour cold coolant into a hot
engine.
6. Remove reservoir cap (Figure 15, (4))
to add coolant if necessary. Do not add
water.
7. Install filler cap and tighten it firmly.
Failure to do so will cause water
leakage.
8. Check the rubber hose (Figure 15, (1))
connecting the reservoir to coolant
tank/heat exchanger. Replace if
damaged.
Note: If the coolant runs low too often or
the coolant level in coolant tank
drops without any change in the
level in the reservoir, there may be
water or air leaks in the cooling
system. Consult authorized
YANMAR dealer or distributor.
Reservoir Capacity
0.8 L (0.85 qt)
3JH40_4JH45_4JH57_4JH80_4JH110_EN_OPM.book 59 ページ ２０２２年９月２２日 木曜日 午後６時１７分
To Next Page
