YASKAWA CIMR-V7xx20P1 series - Page 40

Drive Parameter Listing
(n053-n058) Section 8
PARA- SETTING RANGE SETTING FACTORY USER PARA.
METER NAME (AND UNITS) INCREMENT SETTING SETTING REF.
9: Multi-step speed ref. cmd. D
n053
Multi-function Input
10: JOG Selection
15
Selection 4 (Terminal S4)
11: Accel/Decel time change cmd.
(5)
12: External Base Block (N.O.)
n054
Multi-function Input
13: External Base Block (N.C.)
16
Selection 5 (Terminal S5)
14: Speed search from max. freq.
(6)
Multi-function Input
15: Speed search from set freq.
n055
Selection 6 (Terminal S6)
16: Accel/Decel hold command
17
17: Remote/Local selection
(7)
18: Serial Communication / control ckt.
selection
19: Fast Stop - Fault (N.O.)
5.18
20: Fast Stop - Alarm (N.O.)
n056 Multi-function Input
21: Fast Stop - Fault (N.C.) 1 10
Selection 7 (Terminal S7)
22: Fast Stop - Alarm (N.C.) (10)
23: PID control off
24: I value reset (PID)
25: I value hold (PID)
26: Over Heat Pre-alarm OH3
27: Accel/Decel Time Select 2
34: Up
0: Fault
Multi-Function Output
1: During running
n057 Selection 1
2: Speed Agree
10
(Terminals MA, MB & MC)
3: Zero Speed
4: Frequency detection 1
5: Frequency detection 2
6: Overtorque detection (N.O.)
7: Overtorque detection (N.C.)
8: Undertorque Detection (N.O.)
Multi-Function Output
9: Undertorque Detection (N.C.) 1 1
n058 Selection 2
10: Minor Fault
5.19
(Terminals P1 & PC)
11: During Base Block
12: Local / Remote
13: Ready
Drive Parameters - Continued
40
IG.V7.01_new format.qxd 4/18/05 1:21 PM Page 40