8 Electrical Installation
34 YASKAWA TOEPC71061752B GA500 Drive Installation & Primary Operation
Figure 8.1 Standard Drive Connection Diagram
*1 Set the wiring sequence to de-energize the drive with the MFDO. If the drive outputs a fault during fault restart
when you use the fault restart function, set L5-02 = 1 [Fault Contact at Restart Select = Always Active] to de-
energize the drive. Be careful when you use a cut-off sequence. The default setting for L5-02 is 0 [Active Only when
Not Restarting].
To Next Page
Loading...
