12 Drive Control, Duty Modes, and Programming
YASKAWA ELECTRIC TOEP C710617 17B YASKAWA AC Drive GA700 Initial Steps EN 25
5. Push or to select [C1 Accel & Decel Time], then push .
6. Push or to select C1-01, then push .
7. Push or to select the specified digit. Push or to select the correct number.
• Push [Default] to set the parameters to the factory default.
• Push [Min/Max] to move between the minimum value and maximum value.
8. Push to keep the changes.
9. Continue to set parameters or push [Back] to go back to the HOME screen.
12 Drive Control, Duty Modes, and Programming
◆ Drive Control Methods
This section gives information about these basic motor control methods:
• V/f Control (V/f)
• Open Loop Vector control (OLV)
• EZ Vector Control for induction motors only (EZOLV)
Refer to the Technical Manual for information about speed feedback and Permanent Magnet/Synchronous
Reluctance motor control methods.
Use parameter A1-02 [Control Method Selection] to set the correct motor control method for the application.
EN
To Next Page
Loading...
