6-7
166465-1CD
166465-1CD
Auto-Axcess DI/E Digital
6 Miller Auto-Axcess E Digital
6.2 MACRO Job Settings
6.2.3 MILLER-CHNG-WELD Macro
The "Miller-Chng-Weld" macro is used to ensure 100% synchronization
between the robot's motion and the current weld's identifier or can be
used to allow out-of-sequence welding. This may be needed when
processing parts that are affected by heat-input and could warp because
of heat-input.
• Welder Number: Allows specification of the desired welder.
Allowable values are 1 to 4.
• Weld ID: Specifies the upcoming weld's ID# which correcelates to
the ID and limits specified within the "CenterPoint" application.
Fig. 6-5: MILLER-CHNG-WELD Macro Screen
To Next Page
Loading...
