YASKAWA MOTOMAN DX100 - Home Screen; Program Selection Screen

3-5
166465-1CD
166465-1CD
Auto-Axcess DI/E Digital
3 Equipment Description
3.5 Miller-Motoman Pendant Interface (HMI) Software
3.5.3 Home Screen
The Home Screen (Fig. 3-4) will take you to the various applications
shown on each button. These screens are described in more detail later.
Fig. 3-4: Home Screen
1. View data for: If more than one welder is attached to the system,
select the welder that you want to work with.
3. Quit: This button closes the application and returns the user to the
pendant programming menus. To re-enter the program, passwords,
etc. must be entered. During normal system operation, if the program
is not needed, it should be closed.
3.5.4 Program Selection Screen
The Auto-Axcess DI/E Digital can have eight user definable weld
programs (Fig.3-5 Program Selection Screen). Each program can be
configured for the process, wire size and type, and shielding gas.
3
1
2
2
2
2
2
2
2
2. Program Selection:
Prog Sequence Setup:
Live Weld Data:
Welder Memory Addr:
Errors Config:
Lock/Unlock Editing:
Backup/Load Settings:
These buttons bring up additional screens
for editting or viewing data functions.
NOTE
Some of the set-up functions cannot be changed in Play
mode.
23/56