6 Miller Auto-Axcess E Digital
6.2 MACRO Job Settings
6-8
166465-1CD
166465-1CD
Auto-Axcess DI/E Digital
6.2.4 MILLER-END-PART Macro
The "Miller-End-Part" macro is used to signal the completion of a part.
This causes the robot to stop accumulating cycle time and display any
"Part Errs" if they occurred during the course of the part.
• Welder Number: Allows specification of the desired welder.
Allowable values are 1 to 4.
Fig. 6-6: MILLER-END-PART Macro Screen
To Next Page
Loading...
