YASKAWA MOTOMAN DX100 - Starting the HMI Software; Welcome Screen

3-3
166465-1CD
166465-1CD
Auto-Axcess DI/E Digital
3 Equipment Description
3.5 Miller-Motoman Pendant Interface (HMI) Software
3.5.1 Starting the HMI Software
To start the HMI program tap the {ARC WELDING} button, then the {Miller
DI} button (Fig. 3-2).
The first time the program is launched the Welcome Screen appears
(Fig. 3-3 Welcome Screen on page 3-4). Once configuration of the
program is complete, touching the {MILLER DI} will bring up the Home
screen shown in Fig. 3-4 Home Screen on page 3-5.
Fig. 3-2: Start Up Screen
3.5.2 Welcome Screen
The Welcome Screen appears the first time the Miller Human Machine
Interface (HMI) application is loaded onto the DX100 programming
pendant. This screen configures the system for the number of welders,
type of communication, addressing, and passwords being used.
NOTE
This screen is usually set up by Yaskawa Motoman.
21/56