3 Equipment Description
3.5 Miller-Motoman Pendant Interface (HMI) Software
3-6
166465-1CD
166465-1CD
Auto-Axcess DI/E Digital
Fig. 3-5: Program Selection Screen
1. View data for: If more than one welder is connected to the system,
select the welder you wish to view.
2. Program 1, 2, 3, 4, 5, 6, 7, 8: Select the required welding program.
Only those programs that are used need to the configured. To specify
a new process in a program:
• Using the stylus touch the down arrow button
on the right of
the Program Selection Screen (Fig. 3-5). The list of process
options will be displayed.
• Scroll though the list to view the process options. They are listed
in the following order: Mode, Material, Wire Size, Gas Mixture
• Select the desired process.
3. Save: After changing a program press this button to save the program
changes to the welder. If {Save} is not pressed, any changes are lost
when leaving this screen. After pressing the {Save} button, a
prompted will appear to OK the changes. Press {Yes} to save or {No}
to discard the changes.
1
2
3
The use of a stylus is recommended to ensure selection of
the information you want to program.
Save Disabled displays on the pendant if the Manager has
not assigned the operator the rights to make process
changes. To restore the SAVE function, go to the Lock/
Unlock Edit Screen (Fig. 3-10) and log-in with the
Manager’s password.
To Next Page
Loading...
