YASKAWA MOTOMAN DX100 - Page 37

4 Interface with an Easy Offline Teaching System
DX100 4.1 Job Data Format
4-5
156191-1CD
HW0482494
 RECTAN
Function: Represents that Cartesian data is defined during and after this
pseudo instruction.
Format: ///RECTAN
<Cartesian data>: <C>|<BC>|<P>|<BP>
<C>: <Cxxxxx> = <X>,<Y>,<Z>,<Rx>,<Ry>,<Rz>,<Re>
<BC>: <BCxxxxx> = <1>,<2>,<3>
<P>: <Pyyyy> = <X>,<Y>,<Z>,<Rx>,<Ry>,<Rz>,<Re>
<BP>: <BPyyyy> = <1>,<2>,<3>
<Cxxxxx>: Robot axis teaching position
<BCxxxxx>: Base axis teaching position
<Pyyyy>: Robot axis position variables
<BPyyyy : Base axis position variables
<X> : X-axis Cartesian data
<Y> : Y-axis Cartesian data
<Z> : Z-axis Cartesian data
<Rx> : Rx-axis Cartesian data
<Ry> : Ry-axis Cartesian data
<Rz> : Rz-axis Cartesian data
<Re> : Re-axis Cartesian data
<1> : 1-axis Cartesian data
<2> : 2-axis Cartesian data
<3> : 3-axis Cartesian data
 RCONF
Function : Represents the manipulator type of the Cartesian data defined
during and after this pseudo instruction.
Format : ///RCONF <
l >,< m >,< n >,< o >,< p >,< q >,< r1 >,< r2 >,< r3 >,
< r4 >,< r5 >,< r6 >,< r7 >,< r8 >,< r9 >,< r10 >,< r11 >,
< r12 >,< r13 >,< r14 >,< r15 >,< r16 >,< r17 >,< r18 >
<l>: 0: Flip, 1: No-flip
<m>: 0: Upper arm, 1: Lower arm
<n>: 0: Front, 1: Rear
<o>: 0: R < 180, 1: R >= 180
<p>: 0: T < 180, 1: T >= 180
<q>: 0: S < 180, 1: S >= 180
<r1> to <r18>: unused
For manipulator type, refer to chapter 4.3 “Configuration of Position Data”
at page 4-21.
37/63