4 Interface with an Easy Offline Teaching System
DX100 4.4 Manipulator Type
4-26
156191-1CD
HW0482494
4.4.4 Front/Back
Viewing the L-axis and U-axis from the right side, specify the location of
the B-axis rotation center either right or left side of the S-axis rotation
center.
If its center is at the right side of the S-axis rotation center, it is defined as
“front” and left side is “back”.
The above figures show the S-axis angle at 0°and 180°. Specification
must be performed by always viewing the L-axis and U-axis from the right
side.
S-axis 0
° S-axis 180°
To Next Page
Loading...
