viii
Maintenance and Inspection Precautions
Disposal Precautions
General Precautions
• Do not attempt to disassemble the MP2000 Series Machine Controller.
There is a risk of electrical shock or injury.
• Do not change wiring while power is being supplied.
There is a risk of electrical shock or injury.
• When replacing the MP2000 Series Machine Controller, restart operation only after transferring the
programs and parameters from the old Module to the new Module.
If the MP2000 Series Machine Controller is operated without having transferred the data, there is a risk of
device damage.
• Dispose of the MP2000 Series Machine Controller as general industrial waste.
Observe the following general precautions
to ensure safe application.
• The products shown in illustrations in this manual are sometimes shown without covers or protec-
tive guards. Always replace the cover or protective guard as specified first, and then operate the
products in accordance with the manual.
• The drawings presented in this manual are typical examples and may not match the product you
received.
• If the manual must be ordered due to loss or damage, inform your nearest Yaskawa representative
or one of the offices listed on the back of this manual.
To Next Page
Loading...
