32
Open the front cover and verify that the strip length is 5.5 mm.
Wiring Inspection
After completing wiring, check the following.
• Wiring is proper.
• Wire clippings or screws are not left in the Inverter.
• Screws are securely tightened.
• Bare wires in the terminals do not contact other terminals.
If the FWD (or REV) RUN command is given when the RUN
command from the control circuit terminal is selected (n02 =
1), the motor will start automatically after the main circuit
input power supply is turned ON.
Scale
NOTE
To Next Page
Loading...
