6. Programming Features
43
6. Programming Features
Factory settings of the constants are shaded in the tables.
After wiring is complete, be sure to make the following settings before oper-
ation.
Hardware
Make the following settings before the Inverter is turned ON.
Software (Constant)
Item Ref.
Sequence input signal (S1 to S5) polarity selection 115
Voltage reference / current reference input selection of
control circuit terminal FR
75
Item Ref.
Environment
setting
Constant Selection / Initialization (n01) 44
RUN Command Selection (n02) 49
Frequency Reference Selection (n03) 50
Stopping Method Selection (n04) 67
Basic
characteristics
and frequency
reference setting
V/f pattern setting (n09 to n15) 45
Acceleration Time 1 (n16),
Deceleration Time 1 (n17)
55
Frequency Reference 1 to 8
(n21 to n28)
51
Motor protection Motor Rated Current (n32) 81
Electric Thermal Motor Protection
Selection (n33)
81
Countermeasure
for noise and
leakage current,
Using an optional
braking resistor
Carrier Frequency Reference (n46) 64
To Next Page
Loading...
