YASKAWA VS MINI J7 series - Display List; Software No. Display

6. Programming Features
91
 Software No. Display
The software number of the Inverter for which constants are stored in
the Digital Operator is displayed.
Example: Displaying Software No. of Inverter for which Constants are
Stored in EEPROM in Operator
* Displays the lower 3 digits of the software version.
 Display List
Explanation Operator Display
• Enable the setting for
constants n01 to n79.
• Press DSPL to light [PRGM].
• Press ENTER to display the
set value.
• Change the set value to 4 by
pressing the or key.
• Press ENTER.
(May be a different constant No.)
(Lit)
(May be a different constant No.)
(Flashes)
(Lit for one second.)
↓
(The constant No. is displayed.)
• Execute Software No.
Display (Sno)* using
the Constant Copy
Function Selection
(n76).
• Change the constant No. to
n76 by pressing the or
key.
• Press ENTER to display the
set value.
• Change the set value to Sno
by pressing the or key.
• Press ENTER.
• Press DSPL or ENTER.
(Lit)
(Lit)
(Lit)
(Software version: VSP020011)
(The constant No. is displayed.)
Operator
Display
Description Corrective Action
Lit: Constant copy function selection
enabled.
-
Lit: READ selected.
Flashes: READ under execution.
-
Lit: Writing (COPY) selected.
Flashes: Writing (COPY) under execu-
tion.
-
Lit: VERIFY selected.
Flashes: VERIFY under execution.
-
Lit: Inverter capacity display selected. -
Lit: Software No. display selected. -
Lit: READ, COPY (writing), VERIFY
completed.
-