Yealink CP860 - Placing Calls

User Guide for the CP860 HD IP Conference Phone
72
Placing Calls
You can press the off-hook key either before or after entering the number to place a call. You
can also dial an entry from local directory, favorite directory, remote phone book or call history.
For more information, refer to Contact Management on page 35 and Call History Management
on page 49.
The call duration and far-site’s information (name and phone number) are visible on the LCD
screen. In the figure below, the call to “Bob” (the phone number: 1050) has lasted 7 seconds.
To place a call:
Do one of the following:
- Press to obtain a dial tone.
Enter the desired number using the keypad.
Press , , or the Send soft key.
- Enter the desired number using the keypad.
Press , , or the Send soft key.
The # key is configured as a send key by default. You can also set the * key as the send key, or
set neither. For more information, refer to the Key As Send on page 30.
Note
The CP860 IP conference phone can handle multiple calls at a time. However, only one active
call (the call that has audio associated with it) can be in progress at any given time.
To place multiple calls:
You can have more than one call on your CP860 IP conference phone. To place a new call during
an active call, do one of the following:
- Press . The active call is placed on hold.
Enter the desired number using the keypad.
Press , , or the Send soft key.
- Press the Hold soft key to place the original call on hold.
You can also dial using the SIP URI or IP address. To obtain the IP address of a phone, press the
OK key when the phone is idle. The maximum length of SIP URI or IP address length is 32
characters. For example, SIP URI: 3606@sip.com, IP: 192.168.1.15 or 192*168*1*15.
Your phone may not support direct IP dialing. Contact your system administrator for more
information.