| Powering on or off | 10
• The distance between the camera and the LCD TV is about 10cm.
• The camera should not face the light source directly, to prevent bad experience caused by dazzling
light.
Recommendations of CTP18 Installation
You can place CTP18 on the table or install is on the wall.
For more information about installing CTP18, refer to Yealink CTP18 Quick Start Guide (EN, CN, DE, ES,
FR) V1.0.
Powering on or off
After you connect the system (MeetingBar A20 and CTP18) to a power supply, it will automatically power
on. The system does not have a power button, so you must unplug the power cable to turn off the power.
Initial Setup
After MeetingBar A20 and CTP18 are powered on for the first time (or reset to factory), you need to
complete the initial settings on CTP18 to use CTP18 as the controller of MeetingBar A20.
Procedure
1. Pair CTP18 and MeetingBar A20 via IP address.
2. Select the corresponding language and tap Next to go to the Zoom Rooms page.
• Pairing CTP18 with MeetingBar A20
Pairing CTP18 with MeetingBar A20
Before using CTP18 as a Zoom Rooms controller, you need to pair CTP18 (pre-installed with Zoom Rooms
Controller) and MeetingBar A20 (pre-installed with Zoom Rooms) via IP address.
Before you begin
Make sure that CTP18 and MeetingBar A20 are in the same LAN.
To Next Page
Loading...
