Yealink MeetingBar A20 - Network Settings; Configuring Ipv4 Network

| Network Settings | 23
Network Settings
This chapter introduces how to configure the network of MeetingBar A20 and CTP18.
About this task
Note: If the system has enabled the lock settings feature, you need to enter the room password
before entering the system settings.
• Configuring IPv4 Network
• Connecting to the Wireless Network
• Configuring QoS
• Configuring LLDP
• Configuring the 802.1x Authentication
Configuring IPv4 Network
MeetingBar A20 and CTP18 only support IPv4 network mode. You can configure IPv4 network for
MeetingBar A20 and CTP18 respectively.
Before you begin
Make sure that MeetingBar A20 and CTP18 are in the same LAN.
Procedure
1. On the idle screen, tap Settings > General > System Settings > Network.
2. Enter the administrator password (default: 0000) and tap Enter.
3. Select Collar Bar/Touch Console.
4. Configure and save the following settings:
Parameter Description
DHCP
Enable or disable the endpoint/touch panel to obtain network
settings from the DHCP server.
Note: it defaults to enabled. Change causes system to restart or
reboot.
IP Address
Assign an IP address to the endpoint/touch panel.
Note: it is configurable only when you disable the DHCP.
Change causes system to restart or reboot.
Subnet Mask
Configure the subnet mask of the endpoint/touch panel.
Note: it is configurable only when you disable the DHCP.
Change causes system to restart or reboot.
Gateway Configure the gateway of the endpoint/touch panel.
Note: it is configurable only when you disable the DHCP.
Change causes system to restart or reboot.