Yealink MeetingBar A20 - Recording, Whiteboard, and Features

| Content Sharing | 22
Setting the Hangup Mode
If this mode is enabled, the picture took by the camera is upside down. This mode is applicable to install
the camera on the meeting room ceiling.
Procedure
1. On the idle screen, tap Settings > General > System Settings > Others.
2. Enable/disable the Hangup Mode.
Adjusting the Camera Pan Direction
You can set the camera pan direction as normal or reversed. If you set it as reversed, the camera pan
direction will be reversed when pressing the left and right navigation keys.
Procedure
1. On the idle screen, tap Settings > General > System Settings > Others.
2. Select Normal or Reversed from the drop-down menu of Camera Pan Direction.
Resetting the Camera
Procedure
1. On the idle screen, tap Settings > General > System Settings > Others.
2. Tap Reset Camera to reset the camera to factory settings.
Content Sharing
You can present the content while the device is idle or during a meeting.
• Wired Content Sharing
Wired Content Sharing
You can connect MeetingBar A20 to the PC via VCH51 for wired content sharing.
Procedure
Do one of the following:
• Tap Presentation on the idle screen.
• Generally, you can see the PC content on the display after connecting MeetingBar A20 to the PC. If you
want to stop sharing, tap Share Content > Start Sharing.
Note: For more information on how to connect the VCH51 to the endpoint, refer to Yealink
VCH51 Quick Start Guide.