Yealink MeetingBar A20 - Page 21

| Setting the Camera | 21
2. Configure and save the following settings:
Parameter Description
Display Mode
Configure the display mode of the camera.
• High Definition
• Standard
• Warm
• Custom
Default: Standard.
Saturation
Configure the saturation of the camera's image.
The saturation means the maximum intensity of
color in the image.
Note: the value is from 0 to 100. The default value
is 50.
Sharpness
Configure the sharpness of the camera's image.
The sharpness is an indicator that reflects the
definition of the image plane and the sharpness
of image edge. Increasing the sharpness will
improve the definition of the image. However, if
the sharpness is set too high, the image will look
distorted and glaring.
Note: the value is from 0 to 100. The default value
is 15.
Brightness
Configure the brightness of the camera's image.
Note: the value is from 0 to 100. The default value
is 50.
Contrast
Configure the contrast of the camera's image.
Note: the value is from 0 to 100. The default value
is 50.
Noise Reduction(2D)
Specify the noise reduction (2D) mode.
The available modes are described as below:
• Off
• Low
• Middle
• High
Default: Middle.