Yealink SIP-T5 Series User Manual

Phone Customization
247
Default
1
Web UI
Features > Notification Popups > Display Forward Call Popup
Parameter
features.text_message_popup.enable <y0000000000xx>.cfg
Description
It enables or disables the phone to pop up the message when it receives a new text message.
Note: It works only if “features.text_message.enable” is set to 1.
Permitted
Values
0-Disabled
1-Enabled
Default
1
Supported
Devices
All phones except CP920
Web UI
Features > Notification Popups > Display Text Message Popup
Power LED Indicator
Power LED indicator indicates power status and phone status. It is not applicable to CP920 phones.
You can configure the power LED indicator behavior in the following scenarios:
l The IP phone receives an incoming call
l The IP phone receives a voice mail or a text message
l A call is muted
l A call is placed on hold or is held
l The IP phone is busy
l The IP phone misses a call
Topic
Power LED Indicator Configuration
Power LED Indicator Configuration
The following table lists the parameters you can use to configure the power LED indicator.
Parameter
phone_setting.common_power_led_enable <y0000000000xx>.cfg
Description
It enables or disables the power LED indicator to be turned on.
Permitted
Values
0-Disabled (power LED indicator is off)
1-Enabled (power LED indicator glows red)
For T19(P) E2 phones:
0-Disabled (power LED indicator is off)
1-Enabled (power LED indicator glows yellow)
Default
0
Supported
Devices
All phones except CP920
Web UI
Features > Power LED > Common Power Light On
Parameter
phone_setting.ring_power_led_flash_enable <y0000000000xx>.cfg

Yealink SIP-T5 Series Specifications

General

Brand	Yealink
Model	SIP-T5 Series
Category	IP Phone
Language	English