Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
276
Parameter
edk.edklist.X.enable
[1]
<y0000000000xx>.cfg
Description
It enables or disables Enhanced DSS Keys (EDK) macro X.
Note: It works only if “features.enhanced_dss_keys.enable” is set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
0
Parameter
edk.edklist.X.mname
[1]
<y0000000000xx>.cfg
Description
It configures the unique identifier used by the soft key or DSS key configuration to reference the
enhanced DSS keys entry for macro X.
It cannot start with a digit. This parameter must have a value, it cannot be left blank.
Example:
edk.edklist.2.mname = macro2
Note: If there are two or more same macros, the soft key or DSS key will invoke the macro with the
smallest value of X. It works only if “features.enhanced_dss_keys.enable” is set to 1 (Enabled).
Permitted
Values
String
Default
Blank
Parameter
edk.edklist.X.action
[1]
<y0000000000xx>.cfg
Description
It configures the action string that contains a macro definition of the action that the softkey or DSS key
performs.
This parameter must have a value, it cannot be left blank.
Example:
edk.edklist.2.action = 1013$Tinvite$
Note: It works only if “features.enhanced_dss_keys.enable” is set to 1 (Enabled).
Permitted
Values
String
Default
Blank
[1]
X is the macro ID. X=1-255.
EDK User Input Prompt Configuration
The EDK user input prompt parameters must be used if interactivity with the user is implemented as part of any
macro.
The following table lists the parameters you can use to configure the EDK user input prompt.
Parameter
edk.edkprompt.X.enable
[1]
<y0000000000xx>.cfg
Description
It enables or disables user input prompt X.
Note: If a macro attempts to use an EDK user input prompt that is disabled, the macro execution fails.
It works only if “features.enhanced_dss_keys.enable” is set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
0
To Next Page
Loading...
Need help?
General
