Yealink T27P - Page 480

Administrator’s Guide for SIP-T2_Series_T4_Series IP Phones
466
Details of Configuration Parameters:
Parameters
Permitted Values
Default
network.ip_address_mode
0, 1 or 2
0
Description:
Configures the IP address mode.
0-IPv4
1-IPv6
2-IPv4 & IPv6
Note: If you change this parameter, the IP phone will reboot to make the change
take effect.
Web User Interface:
Network->Basic->Internet Port->Mode (IPv4/IPv6)
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin)
->Network->WAN Port->IP Mode
network.ipv6_internet_port.type
0 or 1
0
Description:
Configures the Internet (WAN) port type for IPv6 when the IP address mode is
configured as IPv6 or IPv4 & IPv6.
0-DHCP
1-Static IP Address
Note: If you change this parameter, the IP phone will reboot to make the change
take effect.
Web User Interface:
Network->Basic->IPv6 Config
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin)
->Network->WAN Port->IPv6
network.ipv6_static_dns_enable
0 or 1
0
Description:
Enables or disables the IP phone to use manually configured static IPv6 DNS when
Internet (WAN) port type for IPv6 is configured as DHCP.
0-Disabled