Yealink W52 - Repeater Mode

User Guide for the W52 Cordless Phone
38
Repeater Mode
Repeater mode extends the radio coverage of the base station. The repeater has the same radio coverage as
the base station. This feature is especially useful for users who require mobility in large dwellings. If the
repeater mode is enabled, and a repeater is registered to the base station, the handset registered to the base
station can be used either in the base station or the repeater coverage area, thereby providing users with greater
freedom in mobility.
To configure the repeater mode via the handset:
1. Press to enter the main menu.
2. Select ->System Settings->Repeater Mode.
3. Press the Change soft key to check the Repeater Mode checkbox.
The LCD screen prompts “Setting takes effect after base reboot. Reboot now or not?”.
4. Press the Yes soft key to reboot the base station.
The base station reboots to make the configuration take effect. The configuration
applies to all the handsets registered to the same base station.
PHONE SETTINGS
Repeater mode and eco mode+ cancel each other out. These two features cannot be used at the
same time.
To use repeater mode, make sure both the base station and handset are upgraded to the supported
firmware version (x.30.x.40 or later).
For more information on how to use DECT repeater with the base station, refer to Yealink DECT
Repeater RT10 User Guide.
NOTE: