3-17
IM 04P02B01-01E
Names of Parts and Run Operations
3
3.11 Resetting the Report Data of the Periodic
Printout
This operation resets the past report data when the recorder is configured to print the
report data (the average, the minimum, the maximum, or the sum) of the measured
values in periodic printout.
Procedure
Resetting the Report Data
1. Press the
FUNC
key.
2. Press the key to select Periodic and then press the key.
Func=Periodic
3. Press the key to select Reset and then press the key.
The report data is reset, and the calculation of the report data starts again from
that point. The screen returns to the data display screen.
Log data=Reset
* When the key or key is pressed while holding down the SHIFT key, the operation is
reversed as when the respective key is pressed by itself.
To Next Page
Loading...
Need help?
General
