PERFORMANCE TEST
2 - 11
SM 700820-01E
2
9) Press the ENHANCED key.
10)Press the Type and select the “Logic” option.
11)Set the “Condition” to “True” and set the 1
st
bit status of POD A to “H”.
The other bits and the bits of the other POD are set to “X”.
12)Connect the 1
st
bit probe of POD A to the CAL terminal.
13)Check the trigger activated correctly. If the logic input signal is displayed, check the
waveform on the screen.
14)Change the connection of the probe and test the other bits in the same manner
15)Change the connection of the other POD and test the all PODs in the same manner.
2.10 Logic Input Function Test
To Next Page
Loading...
