YOKOGAWA DpharpEJX vigilantplant EJX Series - 2. HANDLING CAUTIONS; Installation of an Explosion Protected Instrument; FM approval

IM 01C25T01-01E
3-3
3. OPERATION
Example: Call up the Tag to change the tag number.
Check to see where Tag is located in the menu
configuration. Then, call up the Tag on the display
according to the menu tree (See section 3.3 Menu
Tree).
1
F0304.EPS
Display appears when the
HART Communicator is turned on.
Select Device setup.
EJX:YOKOGAWA
Online
1 Device setup
2 Pres
3 AO
4 LRV
5 URV
DEL SET ESC ENTER
Display Operation
or
EJX:YOKOGAWA
Device setup
1 Process Varlables
2 Diag/Service
3 Basic Setup
4 Detailed Setup
5 Review
DEL SAVE HOME ENTER
×2
or
1
2
Select Basic setup.
EJX:YOKOGAWA
Basic Setup
1 Tag YOKOGAWA
2 Unit kPa
3 Re-range
4 Device information
5 Xfer fnctn Linear
DEL SAVE HOME ENTER
3
Select Tag.
HELP
EJX:YOKOGAWA
Tag
YOKOGAWA
YOKOGAWA
DEL ESC
4
The display for the Tag setting
appears.
See 3.1.4 for data entry.
HELP DEL ENTER
5
After entering the data, set the
HART communicator with the data
entered by pressing ENTER (F4).
EJX:YOKOGAWA
Tag
YOKOGAWA
FI1-1A
6
Send the data to the transmitter by
pressing SEND (F2).
7
* flashes during communica-
tion.
When disappears, the
transmission is complete.
(ENTER)
(SEND)
HELP DEL ESC ENTER
EJX:YOKOGAWA
Basic setup
1 Tag
2 Unit
3 Re-range
4 Device information
5 Xfer fncth
HELP SEND HOME ENTER
EJX:FI1-1A
Basic Setup
1 Tag
2 Unit
3 Re-range
4 Device information
5 Xfer fncth
HELP SAVE HOME ENTER
SEND
3.1.4 Entering, Setting, and Sending Data
Data entered using the keys is set in the HART
communicator by pressing ENTER (F4). Then, by
pressing SEND (F2), the data is sent to the transmitter.
Note that the data is not set in the transmitter if SEND
(F2) is not pressed. As all the data that has been set in
the HART communicator is held in memory unless the
power is turned off, all the data can be sent to the
transmitter at once.
Operation
Entering data on the Tag setting display.
1. Device setup
3. Basic setup
1. Tag
F0305.EPS
EJX:YOKOGAWA
Tag
YOKOGAWA
YOKOGAWA
HELP DEL ESC ENTER
Example: To change from Tag YOKOGAWA to FI1-1A.
Call up the Tag setting display.
F0306.EPS
F O K O G A W A
F I K O G A W A
F I 1 O G A W A
F I 1 - G A W A
F I 1 - 1 A W A
F I 1 - 1 A W A
F I 1 - 1 A
F
I
1
-
1
A
Character to
be entered
Operation Display
Deletes
characters.
(DEL)
When the setting display shown above appears, enter
the data as follows: