unrestricted 17
ymn_installing.fm document release 2.2 last updated 3 May 16
YOMANI ML/XR
OWNER MANUAL
• the keypad and the display are facing the customer
• the terminal is at an appropriate height for the customer:
– for people who will be sitting down to use the terminal, the height of a standard
table is appropriate
– for people who will be standing up to use the terminal, the appropriate height
is between 90 and 120 centimeters
• there is enough space (typically 10 cm on all sides) around the YOMANI, so that it
is easy to:
– insert a chip card in the chip-card reader
– swipe a magstripe card with the magstripe-card reader
– tap a contactless device on to the landing zone
– open the cover of the printer and replace the paper
– reach the reset button
• direct light sources do not make it difficult to read the display or the keypad
Cables
Make sure that cables are positioned so that they:
• allow for the necessary movement of the terminal
• do not get in the way of you or your customers
• are tie-wrapped together, as explained under “Tie-wrapping and attaching cables”
on page [xref]
Keep the cables neatly tied together by guiding them through:
• a hole in the surface which the YOMANI is placed on
• the opening at the back of the YOMANI
To Next Page
