JOHNSON CONTROLS
32
FORM 160.79-O3
ISSUE DATE: 11/09/2018
SECTION 2 – OPTIVIEW CONTROL CENTER
NAVIGATION
System
Used to provide additional system information.
Evaporator
A detailed view of all evaporator parameters, including
the programmable Leaving Chilled Liquid Setpoints.
Condenser
A detailed view of all condenser parameters, including
control of the liquid level functions.
Compressor
A detailed view of all the compressor parameters. This
includes pre-rotation vane control, Hot Gas Bypass
Control, Proximity Probe calibration, and PRV cali-
bration.
Capacity Control
A detailed view of all the Capacity Control parameters
showing what overrides are in effect and what the ac-
tive capacity control output states are.
Motor
A detailed view of the motor controller parameters,
specific to the controller type presently utilized on the
chiller system. This allows programming of the Cur-
rent Limit and the Pulldown Demand Limit values.
Setpoints
This screen provides a single location to program the
most common system setpoints. It is also the gateway
to many of the general system setup parameters such as
Date/Time, Display Units, Scheduling, Printer Setup,
etc.
History
This screen provides access to a snapshot of system
data at each of the last 50 shutdown conditions.
To Next Page
Loading...
