JOHNSON CONTROLS
47
SECTION 2 – OPTIVIEW CONTROL CENTER
FORM 160.79-O3
ISSUE DATE: 11/09/2018
2
Cancel Calibration
This option only becomes available after the calibra-
tion has started.
Accept Calibration
The key is pressed to accept the calibration. This key
option only becomes available after the calibration se-
quence is complete.
Fault Acknowledge
This option is only displayed if a fault is present. Al-
lows clearing of High Speed Thrust Bearing related
shutdowns.
NAVIGATION
Home
Causes an instant return to the Home Screen.
Compressor
Return to the Compressor Screen.
To Next Page
Loading...
