EasyManuals Logo

Yujin Robot YCR-M05 User Manual

Yujin Robot YCR-M05
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
1 2 31 2 3
Using eX500
10
Make sure to set the current time for the set cleaning time.
1.Press the Clock buon on the remote
control. e time on the display
screen will ash.
3. Set the "minute" with the (+)(-) buons on the remote control, and press the Enter buon.
4. When the time is set, it conrms the seing with beep sound.
2. Set the "hour" with the (+)(-) buons
on the remote control, and press the
Enter buon.
Aach the tape at the top of stairs where there is a danger of falling.
If dust accumulates on the fall prevention sensors they may not “see downwards” and the robot may fall.
Place the tape on the oor to prevent the robot from
entering an undesired area.
Install boundary area tape
Bottom
side
Bottom
side
Installing eX500
Set Current Time
Using eX500
Press the Power Buon ( ).
If you press it one more time,
it is turned o.
Intelligent Cleaning
: AUTO+ CLIMB
1. Press the Power Buon ( ).
Make sure the AUTO and
CLIMB icons light up on
the display window.
2. Press the Start Buon ( ).
You can press the Climb Buon on the remote
control to cancel Climb Mode. (If CLIMB
mode is o, the robot does not go over doorsills or
climb onto the carpet or rugs over 0.2 in. in height.)
Start / Stop cleaning
Power On / Off

Other manuals for Yujin Robot YCR-M05

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yujin Robot YCR-M05 and is the answer not in the manual?

Yujin Robot YCR-M05 Specifications

General IconGeneral
BrandYujin Robot
ModelYCR-M05
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals