7
Operating principles of eX500
Principles of the Robotic Vacuum Cleaner
is product recognizes the ceiling and obstacles with the camera and various sensors, and cleans by making a virtual
map in the CPU installed in the main body. It operates by drawing the most ecient map by determining the area that
has been cleaned and the area to clean. (Camera navigation is disabled in random mode.) With about 20 detection
sensors, eX500 can avoid wall or objects. (chair, vase, etc)
It climbs over an obsticle up to 0.79 inches in height, and oor sensors help it to avoid falling down stairs.
Be careful that pets or children do not force the robot to fall by playing with it.
How it works
is product has one main brush, two side brushes and vacuum motor. Debris on the oor is gathered by the
rotating side brushes, and is swept into the dust bin by the rotating main brush.
Tips for effective cleaning
Please follow the instructions below for high cleaning eciency.
- Remove and empty eX500's dust bin aer each use.
- Use the Area Boundary Tape to conne eX500 to a particular room or area, and prevent it from geing too
close to electrical cords, computer cords, or delicate objects on the oor, etc.
(Refer to P.10 Install Boundary Area Tape)
- Remove all the non-xed objects such as toys, magazines or shoes from the cleaning area before cleaning.
- Do not li up or move eX500 manually while operating.
( If you do this, the robot loses its way and skips areas.)
- Make sure to charge for at least 1 hour before using eX500 for the rst time. (Refer to P.9 Charging)
● Refer ence
To Next Page
Loading...
Need help?
General
