OPEN
8
1. Aer turning over eX500, identify the position of
the le and right side brushes.
2. Match the L side brush to the L marked on the boom of
eX500. en match the groove on the xed pin and the
side brush and press on rmly.
3. Match the R side brush to the R marked on the boom of
eX500. en match the groove on the xed pin and the
side brush and press on rmly.
1 2
Mop Plate
Install 2 x AAA baeries before using the Remote Contol.
1. Push the cover of the backside of the Remote Control downward to open.
2. Check (+)(-) of the baeries and install.
3. Match the cover to the groove, and close until “click” sounds.
1. Turn over eX500, and install the Mop Plate by aaching it to the boom of eX500 over the Dust Bin.
2. If Mopping mode is not used, keep the Mop Plate saperate from eX500.
※ In Mopping mode with mop plate aached, there may be cases that it is blocked by carpet, rug, or doorsill, and
cannot go forward normally. In such cases, moving the rug or carpet to one side and using Mopping
mode is recommended.
※ In some oor environments, there may be cases of not being able to go forward normally. If it cannot go forward
normally in the oor environment of marble oor or certain paerns, then also set Climb mode for cleaning.
Ultra Microfiber Mop
● Installing eX500
Pre-operation check list
Assemble side-brushes
Insert remote control batteries
Assemble Ultra Microfiber Mop
Fit the side brush into the xed pin of the robotic
vacuum cleaner matching the same shape.
CAUTION
To Next Page
Loading...
Need help?
General
