ZAPTEC Pro - Safety Instructions

5
English
1. Safety instructions
WARNING!
Before using or maintaining this product, it is important to read the following
safety instructions. Failure to follow and implement all the instructions and
procedures stipulated in this installation manual will invalidate the warranty and
cause Zaptec Charger AS to waive all liability and claims for compensation.
! Read through the instructions carefully and familiarise yourself
withtheequipment before you start using it.
! This equipment may only be installed, repaired and maintained by qualified
personnel. Repairs must be carried out by Zaptec or a pre-approved
workshop.
! All applicable local, regional and national regulations must be followed
wheninstalling, repairing and maintaining the equipment.
! Do not use a product which is damaged in any way. See the information
inthechapter on Support and Repairs.
! Only use approved cabling for the installation.
! Do not insert foreign objects into the Type 2 socket.
! Do not use high-pressure washers to clean the Zaptec Pro. Follow
theinstructions in the chapter on Storage and Maintenance.
! Do not install in a location which is exposed to direct sunlight.
! Adapters are permissible – A conversion adapter from the EVSE plug
mustonly be used if specified and approved by the vehicle manufacturer
orEVSEproducer.
! Do not insert test probes, wires or anything else into the quick-release
connector on the back plate. Voltage tests should be performed directly
onthe terminal screws or using a female connector.
! Read the guarantee at zaptec.com/guarantee or contact Zaptec Support
andrequest a copy.