Zaxcom Nomad - Mirror Drive Select - Nomad 12 Only

90 pages

Save Page as PDF

To Next Page

To Previous Page

MAIN MENU My Nomad / Mirror Card

Mirror Drive Select - Nomad 12 Only

This menu selects if Nomad will mirror to a compact flash card or USB drive. If set to mirror to the compact

flash card Nomad will mirror to the internal mirror card. If set to mirror to the USB Nomad will mirror to a

drive plugged into the USB port on the side of Nomad

Main Page

Default Chapter2
- Table of Contents2
Know Your Nomad7
- Front Panel7
- Left Side9
- Right Side11
- Back Side12
- Home Screen / Meters13
  - Store/Recall a Home Screen Configurations15
- Home Screen Explained16
Main Menu18
- Metadata Page18
- Playback Control Menu19
- Primary Card Record Routing - Nomad 10 and 1221
- My Nomad Menu22
- Fader Assign Matrix30
  - Setting a Cross Point30
- External Fader Assign30
- Memory Menu31
- About Nomad Menu33
- Mode Menu34
- Zaxnet Setup Menu45
- Eng Setup48
- Advanced Setup55
Nomad Input Trim Calibration57
Pressing the Time Code Key59
- Time Code Slate59
- Time Code Jam59
- Enter Time Code60
  - Manually Entering Time Code60
  - Manually Entering User-Bits60
- Time Code Setup Menu61
  - TC Mode61
- Tc Frame Rate61
- Tc Displayed61
- Tc Output61
- Increment Ubits61
- Ub Date Style61
- Auto Date Jam61
Pressing the A-MIX Key62
Pressing the Z-Net Key63
- Zaxnet Transmitter Control63
- Trx Frequency63
- Trim63
Pressing the Bus Key64
- Output Bus Assign Busses64
  - Setting a Cross-Point64
- Mono out Matrix65
- Tape/Ifb out65
- Card Tracktone Enable66
- Card Track Slate Enables66
- Card Tracks Com Enables66
- Card Routing - Nomad 10 and 12 Only67
  - Setting a Cross-Point67
Pressing the Pfl Key68
Pressing the Setup Key69
- Analog Setup Menu69
- Adjustable Parameters69
- Input Compressor Linking69
Main Headphone Setup70
- To Set up Your Headphone Selects70
- Headphone Matrix Setup to Decode Ms Stereo70
Setting up and Engaging Tone71
- Assigning Tone to Output Busses71
- Assigning Tone to Card Tracks71
- Engaging Tone71
- Adjusting the Tone Frequency and Level71
Entering Text72
False Start73
Zaxnet Quick Start Guide74
- Trx Transmitter Control74
- Qrx Ifb Audio Receive75
- Erx Ifb Audio Receive76
Eng /Efp Bag Operation77
- Eng Panning77
- Autotrim78
- Autopan78
- Virtual Fader78
  - Operating Virtual Faders78
Usb Keyboard Support79
- System Requirements79
- Attaching Ausb Keyboard79
- Using the Keyboard79
- Locking the Keyboard79
- Keyboard Shortcuts80
Compact Flash Cards81
Syncing Nomad to a Denecke Slate82
Nomad Connector Assignments83
- Audio Input / Output Connectors (Xlr-3)83
- Audio Input / Output Connectors (Ta-5)83
- Mono & Tape Output Connectors (1/8" Trs or 1/8"Ts)83
- Slate Microphone Input Connector (1/8" Trs)83
- Headphone Output Connectors (1/4" Trs or 1/8" Trs)83
- Power Connector (Hirose-4 Connector)83
- Gpi Remote Roll (Usb Type A)83
- Usb to MIX 8 (Usb Type Ato Db9M)84
- Aes Digital Input / Output Connectors (Db-15)84
- O Utput C Onnectors (Db-15)84
Updating Firmware85
- Upgrading the Firmware85
Nomad Specifications86
- Hardware86
- Specifications87
- Software88
Product Support89
Zaxcom Warranty Policy and Limitations90

Zaxcom Nomad - Mirror Drive Select - Nomad 12 Only

Table of Contents

Other manuals for Zaxcom Nomad

Related product manuals