Zaxcom Nomad - Pressing the A-MIX Key

90 pages

Save Page as PDF

To Next Page

To Previous Page

NOMAD OPERATIONS A-Mix Key

Pressing the A-MIX Key

• When Auto-Mix is enabled pressing A-MIX will display the Auto-Mix menu (providing MP3 is not enabled).

See the Auto-Mixer section of this manual for Auto-Mix operations.

When Auto-Mix is off pressing A-MIX will take you to the Metadata menu.

Main Page

Default Chapter2
- Table of Contents2
Know Your Nomad7
- Front Panel7
- Left Side9
- Right Side11
- Back Side12
- Home Screen / Meters13
  - Store/Recall a Home Screen Configurations15
- Home Screen Explained16
Main Menu18
- Metadata Page18
- Playback Control Menu19
- Primary Card Record Routing - Nomad 10 and 1221
- My Nomad Menu22
- Fader Assign Matrix30
  - Setting a Cross Point30
- External Fader Assign30
- Memory Menu31
- About Nomad Menu33
- Mode Menu34
- Zaxnet Setup Menu45
- Eng Setup48
- Advanced Setup55
Nomad Input Trim Calibration57
Pressing the Time Code Key59
- Time Code Slate59
- Time Code Jam59
- Enter Time Code60
  - Manually Entering Time Code60
  - Manually Entering User-Bits60
- Time Code Setup Menu61
  - TC Mode61
- Tc Frame Rate61
- Tc Displayed61
- Tc Output61
- Increment Ubits61
- Ub Date Style61
- Auto Date Jam61
Pressing the A-MIX Key62
Pressing the Z-Net Key63
- Zaxnet Transmitter Control63
- Trx Frequency63
- Trim63
Pressing the Bus Key64
- Output Bus Assign Busses64
  - Setting a Cross-Point64
- Mono out Matrix65
- Tape/Ifb out65
- Card Tracktone Enable66
- Card Track Slate Enables66
- Card Tracks Com Enables66
- Card Routing - Nomad 10 and 12 Only67
  - Setting a Cross-Point67
Pressing the Pfl Key68
Pressing the Setup Key69
- Analog Setup Menu69
- Adjustable Parameters69
- Input Compressor Linking69
Main Headphone Setup70
- To Set up Your Headphone Selects70
- Headphone Matrix Setup to Decode Ms Stereo70
Setting up and Engaging Tone71
- Assigning Tone to Output Busses71
- Assigning Tone to Card Tracks71
- Engaging Tone71
- Adjusting the Tone Frequency and Level71
Entering Text72
False Start73
Zaxnet Quick Start Guide74
- Trx Transmitter Control74
- Qrx Ifb Audio Receive75
- Erx Ifb Audio Receive76
Eng /Efp Bag Operation77
- Eng Panning77
- Autotrim78
- Autopan78
- Virtual Fader78
  - Operating Virtual Faders78
Usb Keyboard Support79
- System Requirements79
- Attaching Ausb Keyboard79
- Using the Keyboard79
- Locking the Keyboard79
- Keyboard Shortcuts80
Compact Flash Cards81
Syncing Nomad to a Denecke Slate82
Nomad Connector Assignments83
- Audio Input / Output Connectors (Xlr-3)83
- Audio Input / Output Connectors (Ta-5)83
- Mono & Tape Output Connectors (1/8" Trs or 1/8"Ts)83
- Slate Microphone Input Connector (1/8" Trs)83
- Headphone Output Connectors (1/4" Trs or 1/8" Trs)83
- Power Connector (Hirose-4 Connector)83
- Gpi Remote Roll (Usb Type A)83
- Usb to MIX 8 (Usb Type Ato Db9M)84
- Aes Digital Input / Output Connectors (Db-15)84
- O Utput C Onnectors (Db-15)84
Updating Firmware85
- Upgrading the Firmware85
Nomad Specifications86
- Hardware86
- Specifications87
- Software88
Product Support89
Zaxcom Warranty Policy and Limitations90

Zaxcom Nomad - Pressing the A-MIX Key

Table of Contents

Other manuals for Zaxcom Nomad

Related product manuals